2009 CBR Mods
I have lightly modded my bike, I have a few more to go but am taking my time about it.
here is where I am at now.
BRAKES

Brembo P4 calipers, piston spacers, HRC pads, Steel brake lines. These calipers are fantastic, give such great feel, the bite not much better than stock calipers but the release and fine control is wonderful.

Brembo 19×18 billet master cylinder, short folding lever.
This master is made for one finger braking, the levers ratio, the angle and quality makes this master the very top of the range in brake masters, You will see it on MOTOGP, WSBK machines etc.
EXHAUST AND FUELLING

HRC TITANIUM FULL SYSTEM. 4/2/1 This exhaust was built as the first model for the 08 race model. Puts out about 99dB at 5000rpm. Which leaves it a few under race regulations and at a nice volume for street riding. Not too loud and the straightness of the system gives it a nice throaty sound. I have been considering cutting it down by a few inches, would boost the sound levels but also bring it a little closer in on profile.
POWER COMMANDER V I fitted this and havent done much with it since then, Running a map that wasnt made for this exhaust has left the bike guzzling fuel but with more up top power.
AUTOTUNE I have one but still havent fitted it yet.
FOOTPEGS

VORTEX footpegs Black, Basic footpegs they do the job well, adjustable in all directions, I run them down and back to give me leg room but even still i am a little cramped on longer runs. The pegs themselves are very sharp and have a tendancy of grabbing your foot.
On the downside for a streetbike they don’t have any means of attaching the rear brake light to the body.






